To get started with your Pocket NC V2-50 start with the below:
- Read through the printed Quick Start Guide that came with your machine
- Watch the getting started series below
- Work through Demo Spiral Part - Kinetic Control
- Work through the First Part Tutorial
Getting Started with the V2-50, 3 Part Video Series
1/3 Unboxing:
2/3 Startup and Shutdown:
3/3 Tool Setup V2-50CHB:
Tool Setup V2-50CHK:
Cut a Part
Demo Spiral Part: If you purchased the ER40 fixture and B-table stock of delrin or wax you can cut the Demo Spiral Part. If you don’t have the ER40 fixture and stock you can still air cut this part as a demonstration of the workflow of loading g-code and running the machine.
First Part Tutorial: To go through the entire workflow of a part you can follow the First Part Tutorial which uses Fusion 360 to program the tool paths and cut your first part on the Pocket NC V2-10 machine.
Further Resources:
Technical Support: service@pocketnc.com, +1 406-451-3799 or your local reseller