Introduction

Kinetic Control is the newest version of the Pocket NC control software and user interface. It can be installed on any V2 series machine since the software is housed on a microSD card instead of the machine itself. To update an existing V2 machine to the new Kinetic Control software and UI follow the instructions below. If you have a V1 machine that connects over HDMI please contact service@pocketnc.com to discuss update options. 

We are regularly improving and adding to Kinetic Control so be sure to check out the recent updates for Kinetic Control by going to http://pocketnc.com > Help > User Resources > Tutorials > Updating Software > Pocket NC Software Versions.

Boot Up Kinetic Control

NOTE: If your machine was purchased before September 1, 2019 or has a serial number of 1800 or lower, please refer to the appendix at the end of this guide.

...

If you have any issues or unanswered questions, please feel free to reach out to us at service@pocketnc.com.

Appendix

Machines purchased before September 1, 2019, or that have a serial number of 1800 or lower, require a slightly different initial boot up procedure. Those steps are lined out below. 

...