...

• First Release: October 2017 (JD)

• Revision A1.0: February 13, 2018 (JD): updated B table offset values for all three work holding methods from 0.885 to 0.836 inches

• Revision B1.1: April 19, 2018 (JD): updated description of the ER40 collet system on page 8

• Revision C1.2: March, 2021 (QR): Removed sacrificial plate section

• Revision 1.3: April, 2021 (KN): Updated M4 screws supplied

Section 1: Pocket NC Vise

...

The adapter mounts onto the B-table of the PocketNC using 2 ⅛ inch dowel pins and 2 M4 x 8 10 fasteners. The adapter can be installed in any of 8 possible positions on the B Table.

...

Place the adapter onto the B table, line up the holes in the adapter with the dowel pins, you may need to wiggle the adapter as you work it down into place. Make sure that you get the adapter all the way down so that it is flush on the B table. Install the M4 x 8 10 fasteners to fix the adapter in place. Tighten the fasteners only until snug, do not overtighten. Overtightening will damage the threads on the B table.

...