...
Power down the Pocket NC V2 and unplug the USB cord and power cord. Remove the USB from the Beaglebone board since the board will be removed.
Remove the side cover plate. This is the cover on the side of the machine that has the Pocket NC logo and a handful of warning symbols on it. If you wish to completely disconnect this cover please do so after reading Step 2 below.
...
Remove the Beaglebone board (board on the left side of the compartment). To do this use two fingers to carefully wiggle and pull the top left corner and the right side until the Beaglebone board comes out. Carefully guide the parts that extend through the chassis of the machine out of the side pocket.
...